Sc Concrete Finish｜ Other Products

SC Concrete Finish is a decorative, cement-based resurfacing mortar for smoothing, resurfacing, and restoring concrete, and doubles as a breathable waterproofing coating
SC Concrete Finish resurfaces, rubs, sacks, and restores concrete surfaces, and can also serve as a waterproofing coating for vertical concrete and masonry substrates. It creates a uniform, water-resistant surface that fills voids while remaining fully breathable, and works as a consistent alternative to traditional jobsite sacking mixes.
Key Features & Benefits

Waterproof barrier for interior/exterior, above/below grade applications on masonry and concrete
Applies to concrete block, brick, stone, precast, or formed concrete
Consistent texture and uniform color
Fully breathable finish

Application Instructions

Ensure the surface is structurally sound, clean, and free from dirt, release agents, and efflorescence
Mix mechanically with a slow-speed mixer for about 3 minutes, without over-mixing
Add roughly half of the required 5 quarts of liquid first, then gradually add the SC Concrete Finish powder and chosen admixture (water or StrongBond) to a heavy pancake-batter consistency
Let the mix rest 3 minutes to "fatten," then remix and adjust consistency as needed
Brush-applied: use a 6-inch cement mason's brush with long, smooth horizontal strokes; finish all final strokes in one direction for an even texture
Spray-applied: mix with 10-12 pints of liquid using plaster or low-pressure spray equipment

Supporting Documents
Safety Data Sheet (SDS)
Technical Data Sheet (TDS)
Brand:SpecChemSKU:CONFIN-BAGTags:Cementitious Products and LiquidsSize:50 LB Bag (Pack of 6), 50 LB Pail (Pack of 6)